Wall-Mount Boom Arm Stand for Video Lights and Studio Use
A wall-mounted boom arm that removes the floor stand from your lighting setup entirely. The telescoping aluminium pole extends from 43 cm to 110 cm, with a standard 3/8-inch and 1/4-inch screw adapter at the top accepting most studio light fittings. At minimum extension the arm holds up to 10 kg — sufficient for a ring light or small softbox. A lockable ball head allows angle adjustment once the arm is in position. The wall mount plate ships with four anchors and multiple screws for a permanent installation. Suited to compact studios, content creator setups, and any space where floor stands create a trip hazard.
- Telescoping Reach: Extends from 43 cm to 110 cm to position lights overhead, at mid-height, or angled from the side.
- Wall-Mounted Design: Frees up floor space completely, removing trip hazards from cables and stand legs.
- 10 kg Load Capacity: Holds up to 10 kg at minimum extension — suitable for ring lights and small softboxes.
- Universal Screw Adapter: 3/8-inch and 1/4-inch adapter fits most studio lights, flash heads, cameras, and microphones.
- Hardware Included: Four wall anchors and multiple screws supplied for a permanent masonry or stud-wall installation.
Off the Floor, Out of the Way
A wall-mount boom arm solves the floor space problem that standard light stands create. Once fixed to the wall, the telescoping pole extends from 43 cm to 110 cm — enough reach for overhead or side lighting — while keeping the floor completely clear. The lockable ball head adjusts angle without tools, and a standard 3/8-inch and 1/4-inch screw adapter accepts most studio light fittings.
Specifications
The arm extends from 43 cm collapsed to 110 cm fully extended. Section diameters range from 22.6 mm at the top to 29.5 mm at the base. Load capacity is 10 kg at minimum extension and 3 kg at maximum extension. The wall bracket is aluminium alloy. Four wall anchors and multiple screws are included for installation into masonry or solid walls.
Compatible Equipment
The 3/8-inch and 1/4-inch screw adapter is compatible with ring lights, flash heads, softboxes, reflector arms, DSLR cameras, and microphone booms. Check your light's thread before ordering if using a non-standard fitting. Fix the bracket to a wall stud or solid masonry — hollow plasterboard alone is not suitable for loads above 3 kg.
